1、 How to check the customer's presbyopia quickly?

For customers over 40 years old, if you want to know whether there is presbyopia and the degree of presbyopia, you can use the following tools to detect it scientifically and quickly.

Vision Card

Flipper

Retinoscopy Rack Set

Inspection steps:

If the customer wears glasses and the original lens is suitable, test on the original lens. If the customer does not wear refractive glasses and does not wear them directly

1. Place the vision card at the distance that the customer is used to reading, and ask the customer to look at the presbyopia test video at the same time;

2. Take the presbyopia detection flipper lens, adjust the close-up pupil distance and place it in front of the customer's eyes; Ask the customer whether the horizontal line or vertical line of the visual mark is clear;

If the horizontal line is clear, it means that the customer has presbyopia; If the horizontal and vertical lines are as clear or the vertical lines are clear, there is no presbyopia.

3. Then take out the retinoscopy rack set, adjust the pupil distance, put it in front of the presbyopia detection flipper lens, and gradually push it upward from the low degree number to the height number until the horizontal and vertical lines are equally clear. The number displayed next to the lens is the presbyopia degree.

2、 How to quickly and effectively recommend optometry and glasses for presbyopia?

Customers who do not wear glasses usually prefer finished presbyopic glasses. Directly introduce that the pupil distance of the finished Presbyopia mirror is mismatched, and the luminosity of most customers' eyes is different. The luminosity of the finished Presbyopia mirror is the same, and there is no astigmatism, so customers lack experience.

Now use a small tool to increase the sense of experience and enhance persuasion.

Vision Card

Separation Prism Flipper

Inspection steps:

1. First, use the tools in the above steps to quickly measure the customer's presbyopia.

2. Put on the corresponding finished presbyopic glasses, take out the near vision chart and place it at the habitual reading distance. Look at the single eye mark on the near vision chart.

3. Take out the separation prism flipper, adjust the distance between the close pupils, place it in front of the eyes, and ask the customer whether the two lines of visual targets seen by the customer are equally clear.

If they are the same, it means that the luminosity of the customer's two eyes may be the same. You can choose the finished presbyopic glasses. If they are inconsistent, it means that the customer is not suitable for the finished presbyopic glasses and needs optometry.